0
H. Final Checklist
1) Is the icemaker level?
) Are all components, fasteners and thumbscrews securely in place?
3) Is there at least 4" minimum clearance around the condensing unit?
4) Have all shipping cartons, tape and packing been removed from the icemaker and
condensing unit? Are the cube guides and tank separator in their correct positions?
5) Is the icemaker in a site where the ambient temperature is 45°F to +100°F (7°C
to 38°C) all year around?
6) Have all electrical and piping connections been made? Are line sets tightened, secured
and free of kinks?
7) Does the electrical installation meet all national, state and local codes and regulations?
Has the power supply voltage been checked or tested against the nameplate rating?
Has a proper ground been installed to the condensing unit and icemaker unit?
8) Has the electrical power supply been on to the condensing unit for a minimum of
4 hours?
9) Are the water supply line shut-off valve and drain valve installed? Has the water
supply pressure been checked to ensure a minimum of 10 PSIG and a maximum of
113 PSIG?
Note: The icemaker may stop running when the water supply is OFF, or if the pressure
is below 10 PSIG.
10) Have the compressor hold-down bolts and refrigerant lines been checked against
vibration and possible failure?
11) Has the bin control been installed and checked for correct operation? To check, push on
the actuator paddle during the first 5 minutes of the freeze cycle and the ice machine
should stop within 5 seconds.
1) Were all tank hoses and thumbscrews reconnected and secured after installing the bin
control?
Note: Confirm that there is no gap behind the bin control bracket.
13) Has the end user been given the instruction manual, and instructed on how to operate
the icemaker and the importance of the recommended periodic maintenance?
14) Has the end user been given the name and telephone number of an authorized service
agent?
15) Has the warranty tag been filled out and forwarded to the factory for warranty
registration?
