ENGLISH
4
Fig. 4
Water Supply Tap
Inlet Hose
Fig. 2
Downgrade
GOOD
BAD
Upgrade
BAD
1) Attach the free end of inlet hose to the stop valve (Fig. 4), noting
washer is correctly positioned. Hand tighten suf
fi
ciently to provide
leak free joint. It is a wise precaution to have the stop valve within
easy reach.
2) Hand tighten grey
fl
exible outlet hose (accessory) onto the
fi
tting
on the rear of the icemaker as indicated (Fig. 3), ensuring rubber
sealing washer is correctly positioned to obtain a leak free joint. The
pipe can be cut to length as necessary to suit position of main drain.
To prevent water leaks, secure the outlet hose to the drain outlet by
using a hose band.
Note: Jointing compounds should be approved and suitable for
potable water use.
Fig. 3
Inlet Hose
Outlet Hose
Drain Outlet
Power Supply Cord
II. OPERATING INSTRUCTIONS
WARNING
1. This icemaker is designed to produce and store edible ice. To
keep the icemaker hygienic:
* Wash your hands before removing ice. Use the plastic scoop
provided (accessory).
* The storage bin is for ice use only. Do not store anything else
in the bin.
* Clean the storage bin before use (see “III. 1. CLEANING”).
* Keep the scoop clean. Clean it by using a neutral cleaner
and rinse thoroughly.
* Close the door after removing ice to prevent entrance of dirt,
dust or insects into the storage bin.
2. All parts are factory-adjusted. Improper adjustments may result
in failure.
3. If the unit is turned off, wait for at least 3 minutes before
restarting the icemaker to prevent damage to the compressor.
1. OPERATION
The installer will normally commission the icemaker to start the automatic
icemaking process. To ensure continuous operation, make sure that:
* The water supply tap is on,
* The icemaker is plugged into the power supply, and
* The control switch is in the “ICE” position (remove the air
fi
lter to
check).
2. PREPARING THE ICEMAKER FOR LONG STORAGE
1) Move the control switch to the “OFF” position.
2) Unplug the icemaker or disconnect the power supply.
3) Close the water supply tap, and remove the inlet hose.
4) Remove all ice from the storage bin, and clean the bin.
5) Disconnect the silicone hose to drain the water from the water tank.
Reconnect the silicone hose back in its correct position after all of
the water has drained. See Fig. 5.
III. MAINTENANCE
1. CLEANING
WARNING
1. Before carrying out any cleaning or maintenance operations,
unplug the icemaker from the electrical supply network.
2. Ask a trained service person to check and clean the condenser
at least once a year.
Fig. 5
Cube Guide
Water Tank
Silicone Hose
(Connect/disconnect
arrowed part)
Storage
Bin
Over
fl
ow Pipe
