16
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• Flaker and soft cubelet (-SC) models can be installed on an ice storage bin only.
Cubelet models can be installed on either a cubelet-compatible dispenser unit or an ice
storage bin. The ice storage bins listed below are recommended.
Model Number
Bin Width
Recommended Hoshizaki Ice Storage Bin
F-450MAJ
F-801M_J(-C)
F-1002M_J(Z)(-C)(-SC)
22" or Wider B-300 Series
FD-650M_J(Z)-C
FD-1002M_J(Z)-C(-CB)
BD-300 Series
For further options, contact your local Hoshizaki distributor.
•
NOTICE!
Remote models must be connected to an appropriate remote condenser
unit. The remote condenser units listed below are recommended. Connection to a
different remote condenser unit will void the warranty unless Hoshizaki approves
a different remote condenser unit for your specific application. For further
details, contact your local Hoshizaki distributor.
Model Number
Recommended Hoshizaki Remote Condenser Unit
F-1002MRJZ(-C)(-SC)
FD-650MRJZ-C
FD-1002MRJZ-C(-CB)
URC-5FZ
• On low-side models, an R-404A, R-407A, or R-407F parallel rack system is needed.
See "II.H. Parallel Rack System Connection" for refrigeration circuit details.
C. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and towards you.
• Top Panel: Lift up at front slightly, push rearward and lift off.
• Side Panels: Remove the screw. Slide forward slightly and lift off.
Model Shown: FD-650MAJ-C
Fig. 1
Top Panel
Side Panel
Side Panel
Front Panel
