horsch LEEB PT 330, Operating Instructions Manual

Page: 56 / 203

4.4.9 Arm rest
The left arm rest can be folded back and ad-
justed in height, if required.
To adjust the height of the arm rest pry the round
cap (8) off the covering and loosen the hexagon
nut (spanner width 13 mm) behind it. Return the
arm rest to the desired position (5-stage raster)
and tighten the hexagon nut (25 Nm). Reinstall
the covering cap.
The longitudinal inclination of the arm rest can
be changed by turning then hand-wheel (9) ac-
cordingly.
Turning towards the outside (+) lifts the armrest
at the front, turning towards the inside (-) lowers
it at the front.
8
9
+
-
4.4.10 Backrest
CAUTION
Danger of injuring in case of accidents
caused by incorrect head rest and backrest
adjustment! Drive only with correctly ad-
justed head rest.
Pull the lever (10) up to adjust the back rest. Do
not press against the backrest while unlocking it.
The desired position is reached by simultane-
ously loading and unloading the backrest. Re-
lease the lever to lock again.
10
NOTE
After locking it should be impossible to move
the backrest to any other position.
The backrest extension (head rest) can be indi-
vidually adjusted in height by pulling the head
rest out or pushing it in.
56