horsch Leeb 5.280 VL, Operating Instructions Manual

Page: 249 / 308

Canister cleaning
Water systems Basic Pro and water sys -
tem CCS Pro
Pre-cleaning the canister with spraying
mixture
5
1
2
3
4
1. Open the lid on the illuviation valve.
2. Switch on the illuviation valve on the terminal;
the spraying pump starts automatically.
3. Set the switch-over ball valve (5) to suck-
ing-off.
4. Switch on canister flushing (1).
5. Put the canister or any other container over
the canister flushing facility and press it down
for at least 30 seconds. Turn the containers
during this process.
6. Turn off canister flushing (1) again.
7. Close the switch-over ball valve (5) again.
8.
Switch off the illuviation valve on the terminal.
NOTE
Water or chemical emerges from the canister
flushing nozzle, when the pressure plate is
pressed down.
Canister cleaning with fresh water
NOTE
Cleaning the canisters with fresh water dilutes
the spraying mixture concentration!
1. Open the lid on the illuviation valve.
2. To be able to use clean water for illuviation,
the function Recirculate fresh water and the illuvi-
ation valve must be activated on the terminal.
¾
Switch on the illuviation valve on the
terminal. The spraying pump starts auto-
matically.
3. Set the switch-over ball valve (5) to suck-
ing-off.
4. Switch on canister flushing (1).
5. Put the canister or any other container over
the canister flushing facility and press it down
for at least 30 seconds. Turn the containers
during this process.
6. Turn off canister flushing (1) again.
7. Clean the illuviation valve with the washing
gun.
8. Close the switch-over ball valve (5) again.
9. Deactivate the
Recirculate fresh water function
and switch off the illuviation valve on the
terminal.
NOTE
Water exits from the canister flushing, when the
pressure plate is pressed down.
244 245