horsch Leeb 5.280 VL, Operating Instructions Manual

Page: 210 / 308

SectionBox (optional)
The SectionBox is available in the versions with
13 or 18 switches. Border/edge nozzles or sec-
tions can be assigned to the switches (1).
The SectionBox can be used in addition to
the drive lever (main sprayer switch) or alone
to operate the sections. The switch (2) allows
switching between the input devices.
Active sections or border/edge nozzles can be
identified by the illuminated LED of the respec -
tive switch (3).
4
1
2
3
HORSCH SectionBox, 13 sections
¾
When the main switch (4) is activated, all
active sections or border/edge nozzles are
enabled.
¾
When the main switch (4) is deactivated, all
active sections or border/edge nozzles are in
the preselected state.
Pay attention to the allocation of the respective
sections or border/edge nozzles to the switches
of the SectionBox, the Terminal Operating Instructions,
software version 1.4.7 (or higher).
Installation
The SectionBox can be connected with a Sub-D
connector for Cab-In and only in connection with
a Terminal Touch 1200.
NOTE
¾
At the terminal the SectionBox must always
be switched to AUX-N.
¾
For the combination te SectionBox,
the following connection sequence must be
observed!
1 ISOBUS
2 SectionBox
3 Terminal
206 MF