horsch Joker RT Series, Owner'S Manual

Page: 38 / 50

38 | P a g e
Tracking – Electronic Depth Control
Machine may not track straight after initial calibration.
To change tracking of the implement adjust the hitch offset knob.
To Adjust:
1. If machine is tracking to the right turn hitch offset knob clockwise.
2. Raise machine out of the ground completely and click hydraulic to lower back to set point.
3. If machine is still tracking to the right repeat Steps 1 & 2.
4. If machine is tracking to the left turn the hitch offset know counterclockwise.
5. Raise machine out of the ground completely and click hydraulic to lower back to set point.
6. Adjust hitch offset until the machine is tracking straight.
7. If further adjustment is needed past what the offset allows, repeat the steps again for
recalibration.
Recalibrating is only needed when changing tractors. Calibration will be saved once the machine is
calibrated to the tractor.
Offset will only need to be adjusted when tracking is off.