horsch Joker RT Series, Owner'S Manual

Page: 36 / 50

36 | P a g e
Parking the Machine
Only park the machine on a firm and level surface. The Joker can be parked folded in transport position.
• Lift machine to its highest position.
•
Insert provided yellow safety stop to rear axle lift cylinder and front hitch cylinder (electronic
machines). DO NOT LOWER OR REST MACHINE ON YELLOW SAFETY STOPS! A load hold valve is
provided in the hydraulic circuit to support the rear lift and machine. Safety stops are used as a
precautionary measure and for service work of the machine only!
• Pull the spring loaded pin of the jack out to lower the jack base plate and extender. Lower it so it is
just about to the ground and aligns with a hole, and release the spring pin to lock it in to position.
• Using the crank, raise jack to lift hitch off tractor draw bar.
• Disconnect hydraulic lines, road lighting equipment, and depth control wire.
• Unhitch the machine.
Put a block under the front jack as there is excessive amount of weight from front
hitch. Be sure to install any yellow safety stops into position on the front and rear
cylinders.
Front Hitch and Lift Jack
Front Cylinder & Yellow Safety Stop (Electronic Machine Only) Rear Lift Cylinder & Safety Stop w/ Front Bolt-On Safety Stop Bracket
Crank
Spring
Pin
Extender
and Base
Plate
Front Bolt-On
Safety Stop
Bracket Assembly
Rear Cylinder &
Safety Stop
Holder
Front Cylinder &
Safety Stop