horsch Focus 4 TD, Operating Instructions Manual, Page: 30 / 108

4 | Technical data
30 60059040 • 02 • 07/2021 • en
Information on year of manufacture
• Year of manufacture in VIN/Vehicle Identification Number (coded):
Embossed when basic vehicle or undercarriage is manufactured
• Year of manufacture on the type plate:
Time of final production of the machine in the respective equipment version
Due to processes, there may be some periods between the manufacturing of the ba-
sic vehicle and final production. There may be differences therefore with the spe-
cification of the year of manufacture.
4.3 Requirements on the tractor
WARNING
Risk of accident from overloading the tractor.
Ø
Observe the permissible values of the tractor for axle loads, total weight, tyre
load bearing capacity and air pressure.
Ø
Verify the suitability of the tractor before commissioning.
The tractor must meet the following requirements to be able to use the machine as
intended:
Implement attachment
Focus 3 TD 4 TD 6 TD
Tractor link arm* Cat. III – III / IV – IV Cat. III – III / IV – IV Cat. III – III / IV – IV
Adjustable drawbar - Circular drawbar
eye Ø 58 – 79 mm Circular drawbar
eye Ø 58 – 79 mm
Ball head - K 80 K 80
Focus 6 TD 3-point 6.35 TD 3-
point 6.50 TD 3-
point 6.75 TD 3-
point
Tractor link
arm* Cat. III – III / IV
– IV Cat. III – III / IV
– IV Cat. III – III / IV
– IV Cat. III – III / IV
– IV
Adjustable
drawbar Circular draw-
bar eye Ø 58 –
79 mm Circular draw-
bar eye Ø 58 –
79 mm Circular draw-
bar eye Ø 58 –
79 mm Circular draw-
bar eye Ø 58 –
79 mm
Ball head K 80 K 80 K 80 K 80
* Three-point/tractor link arm implement attachment
III: Coupling point distances Cat. III Pin diameter Cat. III
IV: Coupling point distances Cat. IV Pin diameter Cat. IV
II/III: Coupling point distances Cat. II Pin diameter Cat. III
III/IV: Coupling point distances Cat. III Pin diameter Cat. IV