Hornbach 10209832, Mounting Instructions

Page: 44 / 46

86 87
ENGLISH GB GB ENGLISH
Connect the cable to the termi-
nal as follows:
Yellow/Green
N Blue
L Brown
6
Connect the two cable clips of
the remote unit with the cor-
responding clips on the fan
unit 4 .
9
Fit two lamps (max. 46 W / not
included) to the sockets of the
fan unit 4 .
12
Switch on the circuit breaker
of the installation site.
14
Install the ceiling bracket with
the screw kit. Make sure the
ceiling bracket is securely fas-
tened.
5
Slide the remote unit into the
ceiling bracket as shown.
8
Install the cover 1 of the fan
unit by attaching it to the ceil-
ing bracket and reinstall the
screws removed in step 3 .
Tighten all four bracket
screws.
10
Install the luminaire cover 2
with the washer and the ball
head screw to the ventilator 2 .
Check the luminaire cover for
secure fit.
13
At the installation site, fix ade-
quate wall anchors (not includ-
ed) to the ceiling.
4
Switch off the circuit breaker
of the installation site.
1
Hang the fan unit 4 into the
ceiling bracket. Rotate the fan
unit until the rotation latch en-
gages.
7
Install the three blades 5 by
use of two screws, washers,
and spring-washers per blade.
11
Remove the six screws from
the pads on the fan unit and
keep them for step 11 .
2
Remove the left bracket
screws 6 on both sides. Keep
them for step 10 . Loosen the
right bracket screws 1 mm,
but do not remove them.
3
WARNING! Wall anchors must fit the ceiling type, the
weight of the fan, and its torque.
WARNING! The distance between the blades and the
wall should be at least 0.6 m.
Nominal voltage 220-240 V~ / 50 Hz
Rated power 70 W
Fan diameter 112 cm
Lamp 2x E27 / Max 46 W / not included
Speed settings Low - Med - Hi - Off
Protection Class / I
Degree of protection IP44
Weight 7.5 kg
Max. flow rate 207.4 m
3
/min
Sound power level max. 61.7 dB(A)
Remote control
Radio frequency 433.92 MHz ± 100 KHz
Transmit power max. -26 dbm
Batteries 2 x 1.5 V AAA
DECLARATION OF CONFORMITY
Hereby, HORNBACH Baumarkt AG declares that the radio equipment type ”remote control“ is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available
at the following internet address: www.hornbach.com/productcompliance/
TROUBLESHOOTING
Fan does not start. Check circuit beaker respectively circuit fuse.
Disconnect from mains supply and check connection terminals inside
the fan.
Change batteries of remote control.
Light does not work. Disconnect from mains supply and check connection terminals inside
the cover.
Fan runs unevenly
and/or wobbles.
Disconnect from mains supply and check if the blades are correctly
installed to the motor.
Disconnect from mains supply and check if the ceiling bracket securely
fastened at the ceiling.
If the problem persists, start exchanging the position of single blades.
Fan sounds noisy. Disconnect from mains supply and check for loose or overtightened
screws.
TECHNICAL DATA