Horizon Reverse Osmosis Seafari Escape 200, Owner'S Manual

Page: 65 / 126

Chapter
11
Electrical Information
Caution: ELECTRICAL SHOCK HAZARD. A Volt/Ohm Meter will be necessary for some
troubleshooting and subsequent corrective actions. The following procedures expose the technician
to high voltage and electrical shock hazard. Only attempt this if you are a qualified electrician and
surrounding conditions are safe.
Caution: Always allow slack in electrical cables. Allow the cable to enter or leave from the strain
relief in a straight manner for several inches to ensure proper connection, to relieve stress to the
cable and fitting, and to allow ease of detachment and reattachment for maintenance or replacement.
If electrical cables are pulled tight causing them to bend at the strain relief they will pull out of the
strain relief causing a dangerous electrical shock condition, the wire may break, and the strain relief
will lose its watertight integrity.
Caution: Review the “Check Off Q.C. Sheet” that accompanied this Owner's Manual and the
Invoice that accompanied this Seafari Escape System to ensure that it has been configured from
Horizon Reverse Osmosis for the appropriate and proper DC Voltage or AC Voltage, Cycles, and
Phase.
Notes:
1. A 12 VDC System will NOT function from 24 VDC Power.
2. A 24 VDC System will NOT function from 12 VDC Power.
3. An AC 50 Hz System will operate at higher than normal pressure and will over heat the Booster Pump
Motor
4. An AC 60 Hz System will operate at lower than normal pressure, will produce 17% less product water
than specified, and the product water will be high in salt content if connected to a 50 Hz power source.
Remove the Front cover from the system controller to access the Main Terminal Strip and Printed Circuit
Board. System configuration, optional Accessories present, and the specific model all are contributing factors
to the amount of electrical connections required during installation. The following items are listed but may
either not be present (Optional Accessory not ordered) or may already be connected. Track each electrical
wire to ensure proper connection. (*** = Optional Accessory)
Seafari Escape System Required Electrical Connections
• Booster Pump Electric Motor
• Low Pressure Switch
• High Pressure Switch
• Fresh Water Flush Pump Electric Motor
• 3-way Product Water Diversion Solenoid Valve
• *** UV Sterilizer
65