Horizon Mobility Aztec 3 2021, Owner'S Manual

Page: 11 / 36

27/04/2021 11 HZN01/MYN/334
11.2 Seat Removal
To remove seat, depending on the model, undo and
remove the hand - wheel (1) under front edge of the
seat. Lift front of seat about 45 degrees or until the
rear locating hooks clear, once lifted clear pull seat
forward and up.
To replace seat, tilt seat with back of plate down
until the rear mounting hooks locate on the rear
mounting bar on vehicle, lower seat until horizontal
then insert and do up the hand - wheel under front
edge of seat.
NOTE: Only ever hold the seat by the front edge and
the top of the back when removing or replacing it
on the vehicle.
Depending on seat specified, it may be very heavy
and not something the user should consider lifting
on their own.
11.3 Battery Access
To access the batteries, first follow procedure in
(11.2) to remove the seat.
Remove the battery cover by grasping front bottom
edge and pulling firmly to separate “hook and loop”
fastening tape.
The batteries are clamped into the scooter by an
M8 nylon locking nut holding down a metal bar.
Once the bar is removed you can move or lift out
the batteries as required.
DANGER!
To do this first undo nylon locking nut holding down
the battery clamp bar, before undoing the battery
terminals, taking extreme care not to touch any two
terminals together with your spanner, socket driver
or battery clamp, as this may result in a short circuit
causing injury such as severe burns. Permanent
damage to the vehicle or batteries may also occur. It
is suggested that you first remove the lead across
the two front terminals that contains the 100A fuse,
followed by the two rear terminals. When you are
reconnecting the batteries, ensure the correct wires
go to the correct terminals and always follow the
disconnection advise in reverse, connecting the
front fused terminals last.
1
Picture of batteries and battery clamp