5
EN
THE MINT 400 LIMITED EDITION • INSTRUCTION MANUAL
ASSEMBLING AND DISASSEMBLING THE TRANSMITTER HANDLE
Assemble
1. On the top transmitter portion, press the rear button.
2. Slide the transmitter handle into the track.
Disassemble
1. On the top transmitter portion, press the rear button.
2. Slide the transmitter handle out of the track.
INSTALLING THE TRANSMITTER BATTERIES
CAUTION:
If using rechargeable batteries, charge only rechargeable batteries. Charging non-rechargeable
batteries may cause the batteries to burst, resulting in injury to persons and/or damage to property.
This transmitter requires 4 AAA batteries.
1. Remove the battery cover from the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.
CAUTION:
Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to
national regulations.
1. Steering Wheel
Controls direction (left/right) of the model
2. Throttle Trigger
Controls speed and direction (forward/brake/reverse) of the model
3. ON/OFF Switch
Turns the power ON/OFF
4. Throttle Trim/Dual Rate
Adjusts the throttle trim/end points
5. Steering Trim/Dual Rate
Adjusts the steering trim/end points
6. CH 3
7. Indicator Lights
-
Solid blue light—
Indicates radio connectivity and adequate battery power
-
Flashing blue light—
Indicates the battery voltage is critically low. Replace batteries
8. REV
Reverses the steering wheel and throttle functions
9. Antenna
Transmits the signal to the model
1
2
3
8
4
5
6
7
9
TRANSMITTER
Steering Dual Rate
1. Power ON the transmitter.
2. Power ON the vehicle.
3. Turn the steering wheel fully left or right on the transmitter and hold that position.
4. To add or remove steering throw input, continue to hold the steering wheel,
and press the (+) or (–) Steering Trim button.
Throttle Dual Rate
1. Place the vehicle on a stand, and power ON the transmitter.
2. Power ON the vehicle.
3. Apply either forward or reverse throttle input on the transmitter and hold that position.
4. To add or remove throttle input, hold the throttle input, and press the (+) or (–) Throttle
Trim button.
NOTICE:
Do not adjust the throttle dual rate while the vehicle is powered on and the rear
wheels are in contact with any surface. Adjusting the throttle dual rate may power the mo-
tor, which could cause damage to property or personal injury.
ADJUSTING THE DUAL RATES
The transmitter allows you to adjust steering and throttle dual rates.
BINDING
Binding is the process of programming the receiver to recognize the GUID (Globally Unique
Identifier) code of a single specific transmitter.
The transmitter and receiver are bound
at the factory.
If you need to rebind, follow the instructions below:
1. Connect a fully charged battery to the ESC.
2. Power on the ESC
3. Press the bind button on the receiver. The red LED will flash, indicating the receiver is in
bind mode.
4. Power ON the transmitter. The receiver’s red LED will turn solid when the bind is successful.
5. Power OFF the ESC to save the settings.
6. Power OFF the transmitter.
You must rebind when binding the receiver to a different transmitter.
NOTICE:
Do not attempt to bind the transmitter and receiver if there are other compatible
transmitters in bind mode within 400 feet. Doing so may result in unexpected binding.
CAUTION:
Never remove the transmitter batteries while the model is powered ON. Loss of model control,
damage, or injury may occur.
