EN
4
FORD
®
RAPTOR BAJA REY
®
: 1:10 4WD RTR • INSTRUCTION MANUAL
The recommended battery for the Ford Raptor Baja Rey is an 7.4V, 5000mAh 2S 30C SMART
Technology LiPo battery with an IC3
™
connector (SPMX50002S30H3). If using a different
battery, it should be of similar capacity, dimension and weight. Ensure the battery chosen is
compatible with an IC3 connector. Follow the chosen battery and battery charger instructions
to charge the battery.
SMART TECHNOLOGY BATTERY AND CHARGER, SPECIFICATIONS
AND OPERATION
The included Spektrum S120 SMART Technology battery charger is compatible only with
Spektrum SMART 2–3 cell LiPo batteries or 6–7 cell NiMH batteries. It is not compaptible with
any other battery chemistries or non-SMART batteries.
A USB power source is required for use. A USB-C QC type power source is recommended for
the fastest charge times.
To charge the included battery:
1. Using the supplied Type-C USB cable, connect the charger to a USB power source (
not
included
).
2. Insert the Spektrum™ SMART
Battery IC3™ connector
(A)
into
the charger IC3 port, and insert
the battery balance lead
(B)
into
the charger balance port. Both the
IC3 and balance connectors must
be connected for the charging
process to begin. The battery may
be disconnected from the charger
at any time to stop the charging
process.
IMPORTANT:
NiMH batteries do not have a balance connector.
3. Disconnect the IC3 and balance connectors when the charge and balance cycles are
complete, as indicated by the LED.
4. The LED indicator will glow solid red to indicate a charging error. Follow the operation
steps to ensure proper connection is used to charge the battery.
Refer to the LED indicator table for charger status.
IMPORTANT:
Connecting a non-SMART battery will cause a charge error and the S120 will
not recognize or charge the battery.
LED Indicator
Power On
USB 5V: White LED
USB Quick Charge 2.0/3.0: Blue LED
LiPo:
Purple LED
NiMH:
Yellow LED
Battery Capacity
Less Than 25%
Single Flash
25% – 75%
Double Flash
76% – 99%
Triple Flash
Charge Complete
Green LED (Solid)
Error
Red LED (Solid)
USB-C Port
LED Indicator
Balance Port
IC3 Charge Port
A
B
A
B
A
B
INSTALLING THE BATTERY
1. Ensure the ESC is powered OFF.
2. Slide the button to the right to release the battery door.
3. Install the fully charged battery in the vehicle.
4. Connect the battery to the ESC.
5. Close the battery door and slide the battery door button to the left to secure it.
6. Power ON the transmitter, then the vehicle.
CHARGING THE BATTERY
S120 Specifications
Input USB Type C, power source not included
Input Voltage 5V–12V
Charge Power 18W max (dependant on power supply)
Compatible USB Power Adaptor 5V/1A, 5V/2A, USB Quick Charge (QC) 2.0/3.0
Battery Connector IC3
™
and balance connector
Battery Types LiPo, NiMH (Spektrum SMART Batteries only)
Cell Count 2–3 cell LiPo, 6–7 cell NiMH
Max Output Voltage 13.05V
Max Output Current Up to 2A
