horiba LAQUA-PC1500, Instruction Manual

Page: 43 / 100

pH Setup
25
■
Setup
This section describes all the setup functions available in LAQUA-PC1500 benchtop meter.
● P1 pH Setup
Using P1 pH setup function of the meter, you can:
• Select buffer
• Erase calibration data
To set the pH functions, follow the procedure detailed below:
Prerequisites
• Switch on the meter.
• Press the
key to keep the meter in pH mode.
• Default buffer setup is BUFF USA . You can change it to BUFF NIST or BUFF DIN if
required.
• Erasing previous calibration data is recommended for accurate calibration. Default setup is
NO but to erase the calibration data, you need to change the setup to YES .
To return to the measurement mode, press the key.
Note
Tip