Chapter 3 COND (conductivity) Measurement
46
HORIBA
3.3 COND Measurement
This section describes the procedures of COND measurement.
1.
Press the MEAS key, and tap the channel setting
and the measurement item in the MEAS screen
to set "CH2" and "COND".
2.
Tap
to start measurement.
The measurement value is displayed, and the
HOLD indicator blinks until the reading
stabilizes.
To stop measurement tap
while the
HOLD indicator blinks.
When the reading stabilizes, the value is held
and HOLD indicator lights up.
During instantaneous value measurement, or
when a measurement value is held, you can
store the measurement values by tapping on
the bottom of the screen.
3.
After the measurement is completed, tap
to proceed to the next measurement.
Summary of Contents for LAQUA COND DS-72
Page 1: ...Instruction Manual COND METER DS 72...
Page 2: ......
