horiba IT-480 F, Instruction Manual

Page: 102 / 116

59
6 Settings
6 Settings
When the instrument is connected to a PC by USB cable, you
can use the data acquisition software to change the emissivity,
moving average count, and current output range settings.
Changes to the set values are saved in the instrument.
Refer to "11 Data Acquisition Software" (page 72)

Emissivity
Setting range is 0.100 to 1.999.
Factory setting is 0.950.
This value, which is appropriate for rubber plastic, paper, glass,
ceramics, foods and various painted surface, is effective enough
for accurate temperature measurements.
Tip
In principle the emissivity is 1 or less, you can set the
emissivity as 0.100 to 1.999 in order to correspond to the
result of other thermometer (contact type or non-contact
type).

Moving average count
Setting range is 1 to 1000.
Factory setting is below:
• IT-480S, IT-480L, IT-480N, IT-480W: 10 (0.2 s)
• IT-480F, IT-480P: 50 (1.0 s)
Increasing the moving average count reduces the output
fluctuation width, but slows the response speed.