horiba APNA-370, Operation Manual

Page: 106 / 113

10 APPENDIX
94
As illustrated, this instrument requires 222 mm for its vertical space when installed on a 19-
inch rack or cut panel.
It also requires 4 mounting screws and a supporting base.
For the mounting plate and sliding rails, use the optionally available ones.
To install the instrument on a desktop, remove its securing plates located on both sides, which
are used for installation on a rack or cut panel.
For a rack or panel, use a supporting base for the bottom of the APNA-370.
Service space
Allow sufficient service space in front of, and behind the instrument.
Fig. 103 Mounting the APNA-370 on a 19-inch rack
The following figure shows a cut panel and its screw positions.
Fig. 104 Mounting the APNA-370 on a panel
As illustrated, place a supporting base behind the instrument.
Note
The mounting plate and sliding rails are available optionally.