horiba ABX MICROS ES60, User Manual

Page: 20 / 200

ABX Micros ES60 OT/CT
1–4 User Manual - RAB237AEN
1.3. Safety Precautions
1.3.1. Electronic and moving parts
The following parts must not be handled or checked by the user:
◆
Electrical power supply.
◆
Electronic circuit boards.
◆
The ABX Micros ES60 OT/CT responds to IEC61010-1 (2002).
1.3.2. Biological risks
◆
If need be, use disinfectant product for instrument decontamination (including touch screen).
See Section 7,
3.1. General cleaning of the instrument, page 7-5 .
◆
Operator injury may occur from an electric shock. Electronic components can
shock and injure the user. Do not tamper with the instrument and do not
remove any components (covers, doors, panels and so on) unless otherwise
instructed within this document.
◆
Moving parts: it is strictly forbidden to disable sensors as it may cause
operator injuries. Protection covers must not be opened during instrument
operations.
◆
The battery may explode if it is not replaced correctly! Ask your local
HORIBA ABX Technical Support Representative, replace only with the same
or equivalent type recommended by the manufacturer. Dispose of used
batteries according to the battery manufacturer's instructions.
Consider all specimens, reagents, calibrators, controls, etc. that contain
human blood or serum as potentially infectious! Use established, good
laboratory working practices when handling specimens. Wear protective gear,
gloves, lab coats, safety glasses and/or face shields and follow other bio-
safety practices as specified in OSHA Blood borne Pathogens Rule (29 CFR part
1910. 1030) or equivalent bio-safety procedures.