Horiba Scientific LAQUAact D-72G, Instruction Manual

Page: 56 / 94

Printing measured values and calibration data
36
●
Printing measured values and calibration data
You can print out the measured value or calibrated value displayed on the instrument, or
the measurement data or the calibration data saved in the instrument. If repeatability
inspection has been inspected, the inspection data is printed out with the calibration
data.
Pressing the
key starts printing during displaying the data you want to save. Use the
printer cable (“ Options ” (page 69)) to connect the printer unit with the instrument
beforehand. If the automatic data memory is set to "ON", you cannot print out in the
measurement mode.
Reference
For details of how to display measurement data and calibration data, refer to the respective
section.
“ Displaying saved data ” (page 31)
“ Displaying the latest calibration and inspection data ” (page 33)
The format of the printout is shown on the below when using pH (two point calibration).
< Measurement data >
Printout format Description
Date : 2013/09/01 Measurement date
Time : 09:00 Measurement time
Channel : 1 Measurement channel
pH : 5.22 Measured value
HOLD : AUTO
HOLD status
Hold value: AUTO
Not hold value: INST
Temperature : 25.5°C ATC Temperature value and temperature setting
Sample : 0000 Sample ID number
Inst. model : D-72 * Instrument model (*Suffix G is not printed.)
Inst. SN : KL1TSE09 Instrument serial number
Elect. status : GOOD Electrode status based on calibration result
Offset : 0.7 mV Asymmetry potential of calibration data
Sensitivity Sensitivity of calibration data
pH 4.01 - 6.86 : 98.9%