Assembly / commissioning
Batteries_Rail_Power_Manual_en02.docx
27
8.
Assembly / commissioning
Target: The battery is connected for use in the vehicle.
Note
Follow the safety instructions, see
2 Safety instructions on page 9.
DANGER!
Danger due to a short circuit between the positive and negative pole of a battery.
If the positive and negative terminals of a battery are short-circuited, there is a risk of overheating
There is an imminent danger with a high risk that will result in death or serious injury if not
Never short-circuit the positive and negative terminals of a battery.
DANGER!
Danger when connecting a battery to the load.
Reversed battery polarity can cause overheating and acid leakage.
There is an imminent danger with a high risk that will result in death or serious injury if not
Always check the correct polarity before making connections.
Make sure that all consumers in the vehicle and the charger are switched off.
Note
If the terminals of a battery are damaged, the battery can no longer be used.
Do not damage the terminals of the batteries.
Note
•
Ensure stable, safe standing areas for carriers/trays/battery cells.
•
Ensure that all consumers in the vehicle and the charger are switched off.
For delivery of so-called battery kits (blocks/cells, connectors, terminal screws):
•
Install the blocks/cells into the battery compartment of the vehicle according to your
customer's installation drawing
•
Install the connectors.
•
Connect the end terminals.
