HTTP/HTTPS
W
EB
GUI
–
W
EB
B
ROWSER
C
ONFIGURATION
I
NTERFACE
8030HEPTA/GPS GPS - NTP Time Server with 2x 10/100/1000 MBit LAN Interface - V04.00
124 / 178
hopf
Elektronik GmbH
Nottebohmstr. 41
• D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
8.3.8 OUTPUT Tab
This Chapter describes the additional functions of the Time Server 8030HEPTA/GPS.
The WebGUI identifies the actual available device specific signal generators and only displays
the corresponding tabs like (PPS / DCF77 / IRIG-
B / …).
The delivery status of the customer specific device can be found in the
accompanying
config-
uration documentation.
Subsequent activation of the Output functionality is
not
possible on site.
8.3.8.1 PPS (Optional Hardware necessary)
The signal generation for the output of a PPS pulse (1Hz) may be configured in this panel.
For the output of this signal additional hardware (at system level) is re-
quired (see system manual if applicable).
8.3.8.1.1 PPS duration
This section serves to select the pulse width to be transmitted. Basically it is possible to specify
the pulse width in milliseconds.
Possible values for the
pulse duration
:
•
Minimum:
1 msec
•
Maximum:
500 msec
8.3.8.1.2 Minimum Sync.-Status for Output
Signal output can be configured only to be generated when the Time Server 8030HEPTA/GPS
has reached a minimum synchronization status. As soon as this minimum synchronization
status drops below this value during operation, the signal output stops unless the TimeOFF
Timer has been set greater than 0. In this case the output is done for the duration of the
TimeOFF Timer despite the minimum synchronization status for the output falls below the
configured value.
