CONTENTS
IMPORTANT INFORMATION
WARRANTY
www.hopetech.com
DISPOSAL
5. Hook & loop cable straps (x3)
6. Rechargeable battery pack
7. Battery Strap
8. Battery charger
1. D rear LED lamp unit
2. QR elastic ring mount
3. Elastic rings (x3)
4. Splitter cable
Light Source:
3 x red Osram Oslon LEDs
Intensity:
105 measured lumens - High
Beam:
270 degrees visibility
Mounting:
QR Elastic Ring Mount
Battery:
7.4v Li-Ion 2600/5200mAh compatible
Charge Time:
3hrs for 2600mAh battery
Weight:
135g with splitter cable
Power Levels:
6 functions
Burn Time:
15 - 200 hours
135g
WEIGHT
POWER LEVELS
6
BEAM ANGLE
270
LUMEN OUTPUT
105
BURN TIME
15-200 HRS
Please take time to read these instructions before use in order to familiarise yourself
with the operation of the lighting system. We strongly advise you read the following
recommendations in order to prevent injury or damage to the lighting system.
WARNING
· This lighting system will withstand harsh wet weather conditions. However, it is not
designed to be submersed in water. Please ensure that the light unit and battery pack
are removed from the bike before washing - particularly if using a high pressure jet
wash.
· Class 2 LED. Do not look directly at the
beam. Permanent eye damage could result.
Consider other road users when mounting
the light to avoid dazzling them. Always
position the light so that it is pointing
slightly downwards so it is not possible to
dazzle road users behind (see fig. 1).
· Keep this light away from children.
· Only connect the rear light to a compatible
Hope Vision 7.4 V battery pack, either directly
or through the supplied splitter cable. Any
attempt to use or charge another battery pack
may result in an explosion and/or serious injury.
· Do not short-circuit the battery terminals. This causes the battery to overheat and
could result in fire or explosion.
· The battery charger is designed for indoor use only and should not come into
contact with water.
· The battery charger contains dangerous voltages and the cover should not be
removed. Any attempt to open the charger will invalidate the warranty.
Fig. 1
horizontal
All Hope Technology lighting systems are covered for one year from original date of purchase
against manufacturer defects in material and workmanship. Proof of purchase is required.
Product must be returned to Hope Technology to process any warranty claim.
This warranty does not cover any damage caused through mis-use or failing to comply by the
recommendations given in this manual.
This warranty does not affect your statutory rights.
When the equipment has reached the end of its life please dispose
of the components in accordance with your local waste regulations.
Lamps and batteries should be recycled where possible and not
disposed of with regular waste.
Li-Ion
HIGH POWER LED REAR LIGHTING SYSTEM
INSTRUCTION MANUAL
HLDP1ESEU - Kit 1 (Euro)
HLDP1ESUK - Kit 1 (UK)
HLDP2ES - Kit 2 (No Charger)
HLDP3 - Kit 3 (No Battery & Charger)
If you find that the power connectors are becoming difficult to separate, we advise using
a small amount of silicone lubricant on the battery connector to ease fitting.
There are no serviceable parts inside either the light unit or battery pack. Please do not
attempt to disassemble the units, as this will invalidate the warranty. If you find that
there is a problem with the functioning of the lighting system please first check that the
battery pack is fully charged (see Charging the Battery Pack section). If the light still fails
to function please contact Hope Technology.
MAINTENANCE
1
4
5
2
3
1
4
5
2
3
8
7
1
4
5
2
3
6
KIT 1
KIT 2
KIT 3
6
7
