Tap separator over
a bin to remove
any dirt/debris.
Line up the dirt
container lid with the
dirt container Turn
the dirt container lid
clockwise to lock.
Lift to remove brushbar.
Remove and dispose
of old belt. Clean any
debris from spindle
and place new belt
onto spindle.
Using a soft brush
clean any dirt/debris
out of the separator.
The separator should
sit on seal in bottom
of dirt container when
correctly fitted.
Place belt on rounded
area of brushbar without
bristles. Line up right side
of brushbar with base,
push into place. Lift and
push left side of brushbar
until clicks into place.
MAINTENANCE
MAINTENANCE
8
9
Cleaning the separator
Re-fitting the pre-motor filter and separator
Replacing the belt
Using a pair of scissors
remove any threads or hair
caught around the brushbar.
Twist upper hose
connector anti-clockwise
and remove upper hose.
Twist lower hose
connector anti-clockwise
to unlock. Pull and
remove lower hose.
Remove any blockage
by inserting wire coat
hanger into hose.
Removing debris from the brushbar
Removing a blockage from the hose
Lift to remove
post-motor filter.
Remove any dirt/debris.
Rinse under water
(max 40°C).
Leave to dry for 24
hours or until fully dry
before placing back in
the vacuum cleaner.
Cleaning the post-motor filter
24hr
IMPORTANT:
Unplug and switch off vacuum cleaner before performing maintenance or
troubleshooting checks.
IMPORTANT:
Don’t use your vacuum cleaner without all of the filters in place.
IMPORTANT:
If the brushbar does not rotate easily then the belt may not have been fitted correctly.
Make sure the belt is not twisted.
TIP:
To test for a
blockage in hose,
drop a small ball of
paper through the
hose. The paper will
drop through if the
hose is clear.
Turn the dirt container
lid anti-clockwise to
unlock and lift to remove.
Slide the pre-motor filter
into the central separator.
Lie vacuum cleaner on its
back exposing brushbar.
Use a crosshead
screwdriver to remove
6 screws.
Turn the separator
clockwise to remove from
the dirt container lid.
Line up tabs on
separator with tabs
in dirt container lid.
Turn clockwise until
separator clicks
into place.
Lift to remove brushbar
cover from base of
vacuum cleaner.
