OPENING
To open the bladder, slide the red tab on the
bladder cuff outward, then pull up to remove
the sealing cuff. The cuff hinges like a door
and slides off at a diagonal,
as pictured.
FILLING
Unfold the bladder seal at the top of the
bladder. Fill with cool water to the
‘optimum fill line.’
COOLING
Insert ice or frozen gel packs as desired. Check that the water level does not rise
higher the ‘do not exceed’ line.
LOADING
Close the bladder seal flap and then put the sealing cuff diagonally on to the bladder. The cuff hinges on to the
bladder like a door, as pictured. Slide the red tab back into a locked position. Please the cuffed bladder into the HONU
pouch with the tube connectors facing outward.
CONNECTING
Click the two Quick Connector tube attachments into place on the bladder tube
connection points, as pictured. Be sure that the Quick Connector tabs are in an
open position – you will hear a click as the connectors lock into place.
POWER
Connect the USB line from the bladder to the battery pack and turn the switch ‘on.’ Check that pump is running by
monitoring water flow through clear tubing – water should circulate within 15 seconds. Flip the switch to ‘off’ to stop
the pump.
TROUBLESHOOTING FLOW
If water doesn’t flow through the ThermoCore system, turn off the unit and double check the tube-bladder connections.
Check that the liquid level inside the bladder is higher than the optimum fill line and that the pump is completely
submerged. through clear tubing – water should circulate within 15 seconds. Flip the switch to ‘off’ to stop the pump.
1
2
3
4
5
6
7
INSTRUCTIONS
FOR USE
