16
Project Saving Setting
There is no separate save menu or button in the software. As project setting, the software will save
it automatically.
Group and Device Management
After creating and setting the project, the default group is displayed in the window. Right-click the
project name at the top of “Project Explorer”, and then click the item “add” to add new groups. The
window is shown as follows.
Enter a group name and set it as the central group according to the internal system relationship.
Click “OK” to add into project. Click cancel if you do not wish to save the settings. Users can add
many groups for project files this way, and can only use default groups.
Note:
Each group can be configurable with up to 32 X-DCS3000. In emergency mode, only the devices
in the same group can be linked to X-NRI.
A maximum of 8 NRI devices can be configured in a group. Audio sources of NRI can be
broadcasted in the same local group. If NRI is in a central group, the audio sources of NRI can be
broadcasted to all devices in system, but it can be linked to DCS of the same central group for
emergency purpose.
Up to 20 X-NPMS can be included in a group which is used to operate the devices in the group. If
X-NPMS is in a central group, it can be used to control the devices in the whole system.
Right-click a group and the window is shown as:
1.
Click the item “Add” to add device, as shown below:
