Honeywell VX6, Reference Manual, Page: 159 / 356

Wavelink Avalanche Enabler Configuration 139
E-EQ-VX6RG-F VX6 Reference Guide
Scan Config
Note: LXE does not support the Scan Configuration feature on Windows CE
devices.
The Scan Config option under the File menu allows the user to configure
Enabler settings using a special barcode that can be created using the
Avalanche Mobility Center Console utilities. Refer to the
Wavelink
Avalanche Mobility Center User’s Guide
for details.
Exit The Exit option is password protected. The default password is leave. The
password is not case-sensitive.
If changes were made on the Startup/Shutdown tab screen, then after entering
the password, tap OK and the following screen is displayed:
Change the option if desired. Tap the X button to cancel Exit. Tap the OK
button to exit the Avalanche applet.
Avalanche Update Settings
Access: Start | Avalanche | File | Settings
Use these menu options to setup the Avalanche Enabler on the mobile device. LXE recommends
changing and then saving the changes (reboot) before connecting to the network.
Alternatively, the Mobile Device Server on the Wavelink Avalanche Management Console can be
disabled until needed (refer to the
Wavelink Avalanche Mobility Center User’s Guide
for details).
Menu Options
Settings Tab Function
Connection Enter the IP Address or host name of the Mobile Device Server portion
of the Avalanche Management Console. Set the order in which serial
ports or RF are used to check for the presence of the Mobile Device
Server.
Execution
Unavailable in this release.
LXE recommends using AppLock, which
is resident on each Windows mobile device.
Server Contact Setup synchronization, scheduled Mobile Device Server contact,
suspend and reboot settings.
Startup/Shutdown Set options for Enabler program startup or shutdown.