Honeywell VOYAGER 1200G, User Manual, Page: 74 / 288

3 - 10
Base Address
Scan the following bar code to determine the address of the base you are using.
Scanner Modes
The Voyager is capable of working with Bluetooth devices other than the
CCB00-010BT charge base.
Charge Only Mode
There may be times when you want to charge your scanner, but not link to
the base. For example, if a scanner is linked to a Bluetooth device and you
need to charge the scanner, but want to retain your existing link.
In order to program the base for Charge Only Mode, you must link a scan-
ner to it. Once the scanner is linked to the base, scan the
Charge Only
Mode bar code. Any subsequent scanners placed in that base will charge
without linking to it. The scanner used to program the base remains linked
to the base. To unlink this scanner, scan
Unlink Scanner on page 3-11.
Note: When in Charge Only Mode, the scanner periodically wakes up and
beeps. See "Power Up Beeper" on page 4-1 to change this setting.
If you want to charge a scanner and link to the base, use Charge and Link
Mode . If the base is programmed for Charge Only Mode, you must link a
scanner to it first in order to program it for Charge and Link Mode. Scan
the linking bar code on the base to link the scanner, then scan
Charge and
Link Mode .
Default = Charge and Link Mode.
Base Address
Charge Only Mode
* Charge and Link Mode