TL6120
69-1903EF 1/16/06 1/2
The TL6120 thermostat can be used to control an electric heating
system such as a baseboard heater, a radiant floor, a radiant ceiling,
a convector, a fan-forced heater, etc.
The thermostat cannot be used with the following:
•
a resistive load under 2 A
•
a resistive load over 12.5 A
•
systems driven by a contactor or a relay (inductive load)
•
central heating systems
•
One (1) thermostat
•
Two (2) 6-32 mounting screws
•
Two (2) solderless connectors
TURN OFF POWER TO THE HEATING SYSTEM AT THE MAIN
POWER PANEL TO AVOID ELECTRICAL SHOCK.
Loosen the screw under-
neath the thermostat and
separate the front plate
from the back plate.
NOTE: The screw cannot
be completely removed.
Connect the thermostat wires to the power and to the load using
solderless connectors for copper wires. The thermostat wires are not
polarized; meaning either wire can be connected to the load or to the
power supply.
NOTE: All cables and connections must comply with local electrical
codes. This thermostat has tinned copper wires for line and load con-
nections. Special CO/ALR solderless connectors must be used if
these wires will be connected to aluminium conductors.
Mount the back plate to the electrical
box using the provided screws. Insert
the screws through a pair (left or right)
of mounting holes on the back plate.
Re-install the front plate of
the thermostat onto the
back plate and secure it
with the screw underneath
the thermostat.
NOTE
: If there is a protective film or sticker on the thermostat’s
screen, peel it off.
Apply power to the heating system. Verify the installation by checking
that the heater can be turned On and Off by raising and lowering the
setpoint using the
buttons.
ATTENTION
: Keep the thermostat's air vents clean and free from
obstructions at all times.
n
Description
1.
o
Supplied Parts
2.
p
Installation
3.
TL6120
Installation Guide
5-2 Programmable Thermostat
4-wire Installation
2-wire Installation