Honeywell Thor VM3, User Manual, Page: 72 / 378

60 Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide
Step 1b – Mount RAM Clamp to Vehicle
Note: If you are using the RAM ball mount, please go to Step 1a – Attach RAM Ball to Vehicle . If
you are using the RAM plate mount, please go to Step 1c – Attach RAM Plate to Vehicle and
Attach RAM Ball .
1. Determine the position for mounting the RAM clamp mount. The clamp mount can
be used on a beam (such as on a fork lift truck) up to 2.5” (63.5 mm) wide and
approximately 2” (50.8 mm) thick. The clamp may be attached to a thicker beam by
substituting longer bolts (not included). Be sure to position the RAM clamp mount
to allow access to the switches and ports on the bottom of the Thor VM3.
Position the upper clamp piece with ball on the beam. Place the bolts through the
holes in the upper clamp piece.
2. Position the lower clamp piece below the beam. Align the bolts with the holes in the
lower clamp piece.
3. Place the nylon locking nuts on the bolts and tighten the bolts.
Mounting Dimensions
Note: Drawing not to scale.
Upper clamp piece
Bolts
Lower clamp piece
Nuts
2.56” /
65.02mm
1.84” (46.74mm)