Chapter 2 - Set Up A New Thor VM2WG
This page lists a quick outline of the steps you might take when setting up a new Thor VM2WG. More instruction for each step
is listed later in this guide. Please refer to the
Thor VM2WG Reference Guide
for additional information and instruction.
Contact
if you need additional help.
Note:
Installing or removing accessories should be performed on a clean, well-lit surface. When necessary, protect the work
surface, the Thor VM2WG, and components from electrostatic discharge.
Caution
Before shipping, the internal UPS battery must be disconnected.
Please refer to the
Thor VM2WG Reference Guide
for details.
Hardware Setup
1. Connect accessories to the
2.
.
3. Connect power cable to the dock.
4. Secure all cables to the dock with the Strain Relief Cable Clamps.
5. Secure the Thor VM2WG in the dock.
6. Press the power switch on the dock.
7. Press the Power key.
Software Setup
Hardware setup should be completed before starting software setup.
1.
2.
3.
4.
5. Setup Wireless client parameters - Please refer to the
Thor VM2WG Reference Guide
6. Setup
parameters
Please refer to the
Thor VM2WG Reference Guide
for additional information and instruction.
2-1
Summary of Contents for Thor VM2W02
