Installation Instructions for the
ISSUE 5
SS500 Series Temperature Compensated
Hall Effect Sensors
PK 80079
WARNING
PERSONAL INJURY
DO NOT USE these products as safety or
emergency stop devices or in any other application
where failure of the product could result in personal
injury.
Failure to comply with these instructions could
result in death or serious injury.
CAUTION
ELECTROSTATIC DISCHARGE DAMAGE
This component is sensitive to electrostatic discharge
(ESD). Take normal ESD precautions in handling this
product to prevent ESD-induced damage and/or
degradation.
Failure to comply with these instructions will
result in product damage.
CAUTION
WAVE SOLDER DAMAGE
DO NOT wave solder this product. Wave soldering
may negatively affect the sensor performance and
reliability. Subjecting the sensor to wave soldering
will void Honeywell’s warranty.
Failure to comply with these instructions will
result in product damage.
ABSOLUTE MAXIMUM RATINGS*
Supply Voltage
-1 to +30 VDC
Voltage externally
applied to output
+30 VDC max. (OFF only)
-0.5 VDC min. (OFF or ON)
Output ON Current
See Table A.
Operating Temperature
-50 to +160°C
(-67 to +320°F)
Storage Temperature
-65 to +160
°
C
(-85 to +320
°
F)
Magnetic Flux
No limit. Circuit cannot be
damaged by magnetic
overdrive.
* Absolute maximum ratings are the extreme limits that the
device will withstand without damage to the device.
However, the electrical and mechanical characteristics are
not guaranteed as the maximum limits (above
recommended operating conditions) are approached, nor
will the device necessarily operate at absolute maximum
ratings.
SOLDERING INSTRUCTIONS
Honeywell recommends an infrared reflow process
with peak temperatures not to exceed 245°C (473°F)
for 10 seconds maximum.
BLOCK DIAGRAM
TRIGGER
CIRCUIT
AND
AMPLIFIER
SENSOR
HALL
GROUND (-)
Vs (+)
OUTPUT
(0) N.H.
OPERATING CHARACTERISTICS
(over Operating Voltage and Temperature, unless otherwise noted)
Min.
Typ.
Max.
Remarks
TABLE
A
Supply Voltage
3.8
⎯
30 VDC
Output Current
Absolute Limits
Current Consumption
⎯
⎯
10 mA
Supply
Voltage
Output
Current
Max. mA
Output Voltage (operated)
⎯
0.15
0.40
Sinking 20 mA max.
-1 to 24
50
Output Current (operated)
⎯
⎯
20 mA
24 to 25
37
Output Leakage Current (released)
⎯
⎯
10
µ
A
25 to 26
33
Output Switching Time
V
CC
= 12 V,
26 to 27
28
Rise, 10 to 90%
⎯
.05
µ
s 1.5
µ
s R
L
= 1.6 K
Ω
,
28 to 29
19
Fall, 90 to 10%
⎯
.15
µ
s 1.5
µ
s C
L
= 20 pF
29 to 30
15
Operating Temperature Range
-40
°
C to +125
°
C (-40
°
F to 302
°
F)
Note:
To prevent damage to the leads, SS500 Series surface mounted sensors are
supplied
only
on tape and reel.
Sensing and Control