CHAPTER
4
Solaris 7980g User Guide
65
DATA EDIT
Prefix/Suffix Overview
When a bar code is scanned, additional information is sent to the host computer
along with the bar code data. This group of bar code data and additional,
user-defined data is called a “message string.” The selections in this section are
used to build the user-defined data into the message string.
Prefix and Suffix characters are data characters that can be sent before and after
scanned data. You can specify if they should be sent with all symbologies, or only
with specific symbologies. The following illustration shows the breakdown of a
message string:
Points to Keep In Mind
•
It is not necessary to build a message string. The selections in this chapter are
only used if you wish to alter the default settings.
Default prefix = None. Default
suffix = None
.
•
A prefix or suffix may be added or cleared from one symbology or all
symbologies.
•
You can add any prefix or suffix from the
ASCII Conversion Chart (Code Page
(beginning on page 224), plus Code I.D. and AIM I.D.
•
You can string together several entries for several symbologies at one time.
•
Enter prefixes and suffixes in the order in which you want them to appear on the
output.
Prefix
Sc
a
nned D
a
t
a
Suffix
1-11
alpha numeric &
control characters
variable length
1-11
alpha numeric &
control characters
Summary of Contents for Solaris 7980g
