Honeywell Solaris 7980g, User Manual, Page: 70 / 252

56 Solaris 7980g User Guide
prefixes, suffixes, or formatted characters as part of the length (unless using
9999).
4. Character Match Sequences
On the ASCII Conversion Chart (Code Page 1252) , find the hex value that
represents the character(s) you want to match. Make a note of the hex value for
the character(s). If you are using bar codes to create your output sequence, use
the
Programming Chart to read the alphanumeric combination that represents
the ASCII characters. (99 is the universal number, indicating all characters.)
5. End Output Sequence Editor
Use FF to terminate this string or to begin another output sequence. If you are
using bar codes, scan F F. Scan Save to save your entries.
Other Programming Selections
If you are creating an output sequence using bar codes, scan Discard (page 236) to
exit without saving any output sequence changes.
Output Sequence Editor Commands
SEQBLK Sequence editor start command.
SEQPRE Add prefix to complete output sequences.
SEQSUF Add suffix to complete output sequences.
SEQSEP Add separators to complete output sequences.
SEQTTS1 Transmit partial sequence.
SEQIPR Add prefix to partial output sequences.
SEQISU Add suffix to partial output sequences.
SEQISE Add separators to partial output sequences.
TRGSTO Timeout for partial output sequences.
FF Termination string.
Examples outlining how to use these commands are shown below.
Output Sequence Example 1 - Three Symbologies