Honeywell ScanPal EDA71, User Manual

Page: 46 / 92

36 EDA71 User Guide
To learn more About Provisioning Mode see page 65 .
Use the Scan Demo App
Use the Scan Demo app to read barcodes or test your symbology decode settings.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Demos .
3. Swipe left or right on the screen until Scan Demo appears under the turntable.
Tap the center of the box image to open the app.
4. Point the scanner window at the barcode.
5. Press and hold any Scan button or tap and hold the on-screen Scan button.
6. Center the aiming beam over the barcode. Make sure the entire barcode is
inside of the illumination frame.
7. Release the Scan button when the tablet beeps, and the Scan Status LED
briefly turns On. Barcode information appears on the screen.
Note: In the Scan Demo app, not all barcode symbologies are enabled by default. If a
barcode does not scan, the correct symbology may not be enabled.
Change the Scan Demo Symbology Settings
1. In the Scan Demo app, tap in the upper right corner of the screen.
2. Select Symbology Settings .
3. Modify the symbology parameters.
• Tap the check box next to a symbology name to enable (check mark) or
disable (no check mark) decoding for that symbology.
• Tap the symbology name to view and modify additional configuration
parameters for the symbology selected.
4. Tap Back to return to the Scan Demo app.
Use the Imager as a Flashlight
To use the imager as a flashlight.
1. Open Quick Settings (see page 21 ).
2. Tap the Flashlight icon to turn the flashlight on.
3. Select the icon again to turn the flashlight off.