Honeywell ScanPal EDA51, User Manual

Page: 72 / 100

62 EDA51 User Guide
3. Using the mobile computer transfer data through local carrier’s network.
Connect to a Wi-Fi Network
The computer contains an 802.11 a/b/g/n/ac radio to transfer data using WWAN
communications. Before you connect to a Wi-Fi network, you need to know about
your network security protocol and its required credentials.
By default, the 802.11 radio is disabled.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings > Network & Internet > Wi-Fi .
3. Tap Off to toggle Wi-Fi radio On . A list of discovered networks appears.
4. On the list, tap a network name to initiate a connection.
To add a network if it does not appear on the list:
a. Navigate to the end of the discovered network list, and then tap
Add network .
b. Type the Wi-Fi network name (SSID).
c. Choose a security protocol and add any required information.
d. Tap Save .
5. Enter any required information if the network is secured (e.g., password, key or
certificate name).
6. Tap Connect .
Once you connect to a saved Wi-Fi network:
• Tap the network name on the list to view details (e.g., status, signal strength,
speed, frequency, security type). Select
Cancel to close details screen.
• The computer automatically connects to the same network when the network is
in range and the WLAN radio is turned On.
• To remove a network from your saved list, tap and hold the network name and
select
Forget network . You can do this for networks you no longer use.
• To modify a network from your saved list, tap and hold the network name and
select
Modify network . You can do this if you changed your network password.
• To view a list of only your saved networks, tap , and then select Saved
networks .