Honeywell Rapid Eye, Installation Manual

Page: 30 / 82

30
Installation
Figure 2-5 Powering Up the DVR
Powering Down
1. Press and hold the power switch on the front of the DVR for up to five seconds.
2. Unplug the Multi-Media DVR from the uninterruptible power supply (UPS) or wall
outlet.
3. Power down the camera(s) and other hardware.
4. Power down the UPS, if in use.
Unit Recovery
Unit recovery is an internal diagnostic that seldom occurs and cannot be interrupted, even
by powering down the DVR. A unit recovery can take many hours, even dozens of hours on
DVRs with a large storage capacity. If unit recovery occurs repeatedly, contact Honeywell
Technical Support (see the back cover of this manual for contact information).
Rapid Eye Unit Installation Environment
Installation of the equipment in a partially or completely enclosed space (such as a
multi-unit rack or lock box) should be such that the amount of air flow required for safe
operation of the equipment is not compromised.
TM
READY
ALARM
HDD
POWER
READY
ALARM
HDD
UP TO 5 SEC
SW V9.0.12
Rapid Eye V9-DSP
This panel is available by
unlocking the front panel. The
READY, ALARM, and HDD LEDs
show through the front panel.
Lock