Honeywell Rapid Eye Hybrid LT, Installation Manual

Page: 35 / 86

Rapid Eye™ Hybrid LT DVR Installation Guide
Document 800-07766V4 Rev A 35
01/2013
Monitor
PC Monitor: VGA For using LocalView, a VGA monitor can be plugged directly to the DVR.
CRT Monitor: NTSC To use an NTSC monitor as a spot monitor, you need a
VGA-to-NTSC converter. On-screen text may be harder to read on such equipment than on
a VGA monitor.
CRT Monitor: PAL To use a PAL monitor as a spot monitor, you need a VGA-to-PAL
converter. On-screen text may be harder to read on such equipment than on a VGA
monitor.
Caution Do not place a monitor or any other equipment directly on top of the Rapid
Eye Hybrid LT DVR.
Connecting the USB Mouse and Optional Keyboard to the DVR
A USB mouse (included) and PC monitor (not included) are needed when using LocalView
to operate a Rapid Eye Hybrid LT DVR. A USB keyboard (not included) is optional.
1. Connect the mouse (included) to a USB port on the rear panel of the Rapid Eye
Hybrid LT unit.
2. The USB ports on the back panel of the DVR can also be used to connect a USB flash
drive (commonly called a memory stick) and/or a USB keyboard (not included). The
USB flash drive can be used for storing video clips.
Using LocalView to Modify the IP Address of the DVR
If a remote network connection is needed, configure the IP Address of the DVR, using
LocalView, before setting-up a connection using the Admin application. Do so by using
LocalView, to either:
•
Access the network settings of the DVR
- or -
• Use the Quick Setup Wizard