12
www.honeywell.com
PW6K1R1E Wiring and Setup
Specifications
After the PW6K1R1E has received its IP address, the following table describes the
LEDs in the normal running mode. If the communication is lost, the PW6K1R1E
reverts back to the “waiting for IP address” mode:
2.11 Specifications
The interface must be used in low voltage, class 2 circuits only.
The installation of this device must comply with all local fire and electrical codes.
5
Input IN2 Status: OFF = Inactive, ON = Active, Flashing = Trouble
6
Input IN3 Status: OFF = Inactive, ON = Active, Flashing = Trouble
LED
DESCRIPTION
1
On-line, encryption disabled = 0.8 second ON, 0.2 second OFF
On-line, encryption enabled = four pulses, 0.1 second ON, 0.1 second OFF per
second
2
Flashes when there is host communication
3
Flashes when data is received from either reader
4
Input IN1 Status: OFF = Inactive, ON = Active, Flashing = Trouble
5
Input IN2 Status: OFF = Inactive, ON = Active, Flashing = Trouble
6
Input IN3 Status: OFF = Inactive, ON = Active, Flashing = Trouble
Power Input
• PoE Power Input 12.95W, compliant to IEEE 802.3af
- OR -
•12VDC 10%, 900mA maximum
Notes:
• A +12V power input must be powered by a UL 294/UL 609 Listed power
supply with appropriate ratings (12Vdc, 900mA) and the capability to
provide adequate standby power.
• If the PW6K1ICE is powered by Power-Over_Ethernet (POE), it must be
powered by a Listed (ALVY) Altronix, Model NetWay1 POE Injector.
NetWay1 must be powered by a UL 294/UL 609 Listed power supply with
appropriate ratings (24Vac/dc, 1.2A) that is capable of providing adequate
standby power.
Power Output • 12VDC @ 700mA maximum (reader and AUX outputs combined)
• Reader (TB3) 12 VDC (10.3 through 12.6) @ 150mA maximum
• AUX (TB5) 12 VDC (10.7 through 13.0) @ 700 mA maximum
Output
• Form-C Contacts rated at 5A @ 28VDC
Inputs
• 4 unsupervised/supervised, End of Line resistors
• 1k/1k - ohm, 1% 1/4W watt standard