Honeywell PM23c, User Manual, Page: 45 / 164

Chapter 2 – Set Up the Printer
PM23c, PM43, and PM43c Mid-Range Printer User Manual 35
8 Configure the cutter:
• If you have an icon printer, use PrintSet 5 or a printer command
language to configure the cutter.
• If you have a full touch printer, continue with the next step.
9 After the printer finishes starting up, press .
10 Select Settings > Printing > Cutter .
11 In the Cutter Control options, select Automatic .
You can also enable Partial Cut from the Cutter menu.
12 Press to save your settings.
13 Configure the start and stop adjust settings.
About Ribbon
Thermal transfer printing provides a durable printout that is less
vulnerable to chemicals, heat, and sunlight than direct thermal printing.
Make sure you select a ribbon type that matches the media you are using
and that you configure the printer for thermal transfer media.
The printer supports thermal transfer ribbon rolls with the ink-coated side
facing either inward or outward. To determine which type of ribbon you
have, place the ribbon on a piece of paper as shown, and use a pen or
other sharp object to scratch the ribbon. If you see a mark on the paper,
your ribbon is wound ink out.
Determining Whether Your Ribbon is Wound Ink In or Ink Out
)NKOUT
)NKIN