Honeywell PM23c, User Manual, Page: 140 / 164

Appendix B – Default Settings
130 PM23c, PM43, and PM43c Mid-Range Printer User Manual
Wireless 802.11 Security Settings
This section describes the 802.11 security settings. To view these
settings:
• From the printer Main Menu, select Settings > Communications >
Wireless 802.11 > Security .
• From the printer web page, click the Configure tab >
Communications > Wireless 802.11 .
Default Router Sets the IP address of a router that is
used when a device sends a packet
to another subnet or to an unknown
destination. 0.0.0.0
DHCP Response Sets if the printer receives DHCP
responses by broadcast or unicast.
Broadcast
(IPv6) IP
Assignment
Method Sets how the printer obtains an IP
address (for IPv6 networks). Automatic
(IPv6) IP
Address Sets the unique network-level
address that is assigned to each
device in an IPv6 network. Automatic
Wireless 802.11 Network Settings (continued)
Setting Description Default
Wireless 802.11 Security Settings
Setting Description Default
Security Type Selects the protocol the radio uses
to verify its identity and makes sure
that it is authorized to communicate
on the wireless network. None
Association Selects the security method that
the radio uses to get access to the
wireless network. Open/WEP
Pre-Shared Key Defines the passphrase that allows
the radio to authenticate over the
wireless network (for both WPA
and WPA2 security). Range is 8 to
64 characters. None