38
NFS2-640/E Programming Manual —
P/N 52742:L2 7/17/14
Programming
Basic Program
ACS Selection Group H (SLC #1, Detectors 1-64):
3
Output
SLC 1, Module 131 Active
SLC 1, Module 131 Trouble
Controls SLC 1, Module 131
to
to (see note 1)
to (see note 1)
31
Output
SLC 1, Module 159 Active
SLC 1, Module 159 Trouble
Controls SLC 1, Module 159
32
Not Used
33
Output
SLC 2, Module 129 Active
SLC 2, Module 129 Trouble
Controls SLC 2, Module 129
34
Output
SLC 2, Module 130 Active
SLC 2, Module 130 Trouble
Controls SLC 2, Module 130
35
Output
SLC 2, Module 131 Active
SLC 2, Module 131 Trouble
Controls SLC 2, Module 131
to (see note 2)
to (see note 2)
63
Output
SLC 2, Module 159 Active
SLC 2, Module 159 Trouble
Controls SLC 2, Module 159
64
Not Used
NOTE:
1. Point number to Module number relationship is sequential. To determine Point to Module
relationship add 128 to Point number to arrive at Module number.
2. Point number to Module number relationship is sequential. To determine Point to Module
relationship add 96 to Point number to arrive at Module number.
Table 2.20 ACS Group G (2 of 2)
Point
Type
Red LED
Yellow LED
Switch Function
Table 2.21 ACS Group H
Point
Type
Red LED
Yellow LED
Switch Function*
1
Input
Detector 001 Alarm
Detector 001 Trouble
Not Used
2
Input
Detector 002 Alarm
Detector 002 Trouble
Not Used
3
Input
Detector 003 Alarm
Detector 003 Trouble
Not Used
to
to (see note)
to (see note)
64
Input
Detector 064 Alarm
Detector 064 Trouble
Not Used
* Pressing the switch button when the Switch Function is “Not Used” will cause the associated LED to
stop blinking. This is a local acknowledgement at the annunciator only: no message is sent to the panel.
NOTE:
Point number to Detector number relationship is sequential; therefore, point 48 is
Detector 048.