Honeywell N568X, Integration Manual

Page: 52 / 72

A - 2
• The N56XX is mounted and connected to the Honeywell demo board through the 12-pin flex.
• The engine is connected to the host via an 6 foot long, straight USB-A/Micro-B cable (Mouser 538-68784-0003). A clamp-on
ferrite (Fair-Rite p/n 0431173951) was added to USB cable on this configuration.
• The N56XX is operating in USB mode (USBSPD1).
The following pages document the test results.
Note: The charts show the quasi-peak values, which are used to determine pass/fail, while the graphs show maximum hold
values.
Model 1: Corded Unit in TTL-232 Mode (RJ45/RS232)
The illustration below shows a unit similar to the unit tested:
This system passed FCC class B limits at all tested frequencies. The test results are shown in the following charts.
Model 1 - Radiated Emissions Measurements 30-2000 MHz
* All readings are quasi-peak unless stated otherwise.
** Data gathered above 1000 MHz was at a 3m antenna distance with RF absorbing material on the ground plane per
EN55022 A1:2007. No significant amplitudes across the frequency spectrum were measured.
Frequency
(MHz)
Antenna
Height
(Meters)
Antenna
Polarity EUT Angle
(Degrees)
Corrected
Reading*
[db(µV/m)]
Margin
CFR 47 Part 15,
EN55022 Class
“B”, 10 Meter
Limit [db(µV/m)]
35.71 1.00 V 291 23.8 -6.2 30
111.96 1.00 V 305 18.9 -11.1 30
167.98 1.03 V 229 23.2 -6.8 30
35.71 1.00 V 291 23.8 -6.2 30
111.96 1.00 V 305 18.9 -11.1 30
167.98 1.03 V 229 23.2 -6.8 30
666.00 2.40 V 214 34.5 -2.5 37
844.81 2.23 V 361 27.1 -9.9 37
960.11 1.00 V 361 29.0 -8.0 37
665.99 4.00 H 345 26.6 -10.4 37
847.50 2.89 H 75 26.8 -10.2 37
958.64 4.00 H 360 28.7 -8.3 37