HHP Properties
When the MX8 is equipped with a Hand Held Products imager, this option is used to configure imager parameters.
Option
Action
Centering The centering feature is used to allow the user to accurately scan a selected bar code among a group of bar codes
that are located closely together. When centering is turned on, the imager will only decode bar codes that inter-
sect the centering window defined by the user. The centering window must intersect the center of the bar code.
The default centering settings define a 60 pixel square area in the center of the imager's field of view.
The default is disabled. When enabled, the following parameters may be entered.
Top
Valid:0 – 239
Default:120
Bottom
Valid:240 – 479
Default:360
Left
Valid:0 – 319
Default:188
Right
Valid:320 – 639
Default:564
Mode
In
Standard mode
the imager will decode both linear and 2-D symbologies.
In
Aggressive Linear Decode mode
the imager will only read linear symbologies in this mode, but decoding these
is faster and more accurate than Standard Mode.
In
Quick Omni mode
the imager searches for a bar code in a reduced field located around the center of the image.
Decoding is faster in this mode, but the user must center the aiming line over the bar code to be read. Both linear
and 2-D symbologies can be read in this mode.
The default is Standard.
5-33
Summary of Contents for MX8
