L O G G I N G O N A N D G E T T I N G S T A R T E D
Port Forwarding
90
MAXPRO NVR 5.0 Installation and Configuration Guide
5
•
Storage Engine (NEOStorageServer, NEOStorageServer2)
In the router’s port forwarding table, the default ports numbers for these services are mapped
to the public port numbers (8001, 8002, 8003, 8004) of the router.
An external MAXPRO NVR client can access MAXPRO NVRs using the following settings:
•
Server IP: 199.63.245.84
•
Server Port: 8001
•
Controller IP: 199.63.245.84
•
Controller Port: 8002
•
Storage Engine IP: 199.63.245.84
•
Storage Engine Ports: 8003, 8004
Note:
The mapping of the ports 8001, 8002, 8003, 8004 to the respective NVR IP and
ports (20007, 26026, 10000, 10010) helps an external MAXPRO NVR desktop
Client to connect to the MAXPRO NVR system.
Scenario 2: Services mapped to existing ports
A single NVR is configured behind the router, and all the services on the NVR are running on
the default ports. In the router’s port forwarding section specify the default ports. The Internet
client can just specify the public IP Address and default ports to connect to the NVR. The
drawback of mapping to the same ports is that only one NVR can be behind the router.
Figure 5-6 Port Forwarding scenario 2
In the above figure:
There is a single MAXPRO NVR 1 with the default port numbers, 20007, 26026, 10000, 10010
configured for the following services respectively:
•
Trinity Server
•
Trinity Controller
•
Storage Engine (NEOStorageServer, NEOStorageServer2)
In the router’s port forwarding table, the default ports numbers for these services are specified.
Storage Engine port - 10000
,10010
192.168.2.191
10010
Storage Engine port - 10000 ,10010
Summary of Contents for MAXPRO NVR Hybrid PE
