. . . . .
C O N F I G U R I N G M A X P R O N V R
Configuring the Cameras
MAXPRO NVR 5.0 Installation and Configuration Guide
127
Adding IP Cameras / Encoders
The MAXPRO NVR Wizard automatically discovers Honeywell cameras in the network and
adds it to the MAXPRO NVR user interface. Alternatively, you can also discover and add all the
supported cameras in MAXPRO NVR in the
Camera
page.
To add IP cameras
1.
Click the
Configurator
tab. The
System
page displays by default.
2.
Click the
Camera
tab to open the
Camera
page
.
Figure 6-11 Camera page
Note:
All Honeywell cameras that are discovered and added using the MAXPRO NVR
Wizard appear in the
Camera
page when you first open it.
3.
Click the
Auto Discovery
button, the Auto Discovery screen is displayed.
•
Click
Start Discovery
to discover the cameras in the network. By default, the
cameras discovered are displayed under
Cameras Discovered
pane.
The cameras are added based on the IP range and Video Format settings. See the
Configuring the Auto Discovery Settings
for more information.
Only device integrations with auto discovery support are discovered automatically in
the NVR. All other devices need to be added manually.
•
To add only specific cameras, select the required camera check boxes and then
click
Add
Cameras
. The selected cameras appear under the
Camera
pane.
Note:
The cameras added will have the default parameters for all their settings.
Summary of Contents for MAXPRO NVR Hybrid PE
