13 - 65
MSI
When enabled, MSI symbols will be scanned, decoded and transmitted.
Set this parameter by scanning either of the bar codes shown below.
Set Length(s) for MSI
Lengths for MSI may be set for:
•
any length,
•
one or two discrete lengths,
•
or lengths within a specific range.
The length of a code refers to the number of characters, including check digits, the code contains.
Note: Due to the construction of the MSI symbology, it is possible for a scan line covering only a portion of the code to be
interpreted as a complete scan, yielding less data than is encoded in the bar code. To prevent this, select specific
lengths (using MSI One Discrete Length and MSI Two Discrete Lengths) for MSI applications.
See
One Discrete Length (Parameter L1)
This option decodes only those codes containing a selected length. For example, when you want to scan only MSI
symbols containing 14 characters, scan the “MSI One Discrete Length” bar code and then “1” and “4” bar codes using
Default = 4.
To begin setting one discrete length, scan this
MSI One Discrete Length
bar code:
Next, scan two numeric bar codes that correspond to the desired value. Single digit numbers must have a leading zero.
To correct an error or to change a selection, scan Cancel on the Imager Keypad Number Symbols page.
Two Discrete Lengths (Parameter L2)
This option decodes only those codes containing two selected lengths. For example, when you want to scan only MSI
symbols containing 2 or 14 characters, scan the “MSI Two Discrete Lengths” bar code and then “0”, “2”, “1” and “4” bar
codes using
Default = 55.
To begin setting two discrete lengths, scan this
MSI Two Discrete Lengths
bar code:
Enable MSI
* Disable MSI
Summary of Contents for Marathon
