This wireless door / window
contact is intended for use with
Honeywell controls that
support SiX™ series devices.
FC: This wireless door / window
contact is intended for use with
Honeywell controls that
support SiX™ series devices.
SP: This wireless door / window
contact is intended for use with
Honeywell controls that
support SiX™ series devices.
PA: This wireless door /
window contact is intended for
use with Honeywell controls
that support SiX™ series
devices.
A Terminal Block
B Reed Switch
C Magnet
D Tamper
E LED
After enrolling and before mounting permanently, conduct Go/No Go
tests (see the controller’s instructions) to verify adequate signal
strength. Adjust the device location and orientation as necessary.
FC:
After enrolling and before mounting permanently, conduct Go/No
Go tests (see controller’s instructions) to verify adequate signal
strength. Adjust the device location and orientation as necessary.
SP:: After enrolling and before mounting permanently, conduct Go/No
Go tests (see controller’s instructions) to verify adequate signal
strength. Adjust the device location and orientation as necessary.
PA:: After enrolling and before mounting permanently, conduct Go/No
Go tests (see controller’s instructions) to verify adequate signal
strength. Adjust the device location and orientation as necessary.
Enroll
/ Enroll / Enroll / Enroll
Product must be tested at least once each year / Le fonctionnement du produit doit être vérifié au moins une fois par année /
El producto debe ser probado al menos una vez al año / O produto deve ser testado pelo menos uma vez por ano
NOTE: Once enrolled, the device cannot be used with another system until it is removed
from the current controller. See the controller’s instructions.
NOTE: Once enrolled, the sensor cannot be used with another system until it is removed
from the current controller. See the controller’s instructions..
NOTE: Once enrolled, the sensor cannot be used with another system until it is removed
from the current controller. See the controller’s instructions..
NOTE: Once enrolled in a system, the RF6GB cannot be used with another control panel
until it is removed from the current control panel. See the Control’s instructions.