Installation and Technical Manual for the
Limitless™ Multi-Protocol Receiver,
WMPR Series
Sensing and Internet of Things
Issue B
32309669
m
WARNING
PERSONAL INJURY
DO NOT USE these products as safety or emergency stop
devices or in any other application where failure of the
product could result in personal injury.
Failure to comply with these instructions could result in
death or serious injury.
m
WARNING
Honeywell does not recommend using devices for critical
control applications where there is, or may be, a single point
of failure or where single points of failure may result in an
unsafe condition. It is up to the end-user to weigh the risks
and benefits to determine if the products are appropriate for
the application based on security, safety and performance.
Additionally, it is up to the end-user to ensure that the control
strategy results in a safe operating condition if any crucial
segment of the control solution fails. Honeywell customers
assume full responsibility for learning and meeting the
required Declaration of Conformity, Regulations, Guidelines,
etc. for each country in their distribution market.
Failure to comply with these instructions could result in
death or serious injury.
m
WARNING
RF EXPOSURE
To satisfy FCC RF exposure requirements for mobile
transmitting devices, a separation distance of 20 cm or more
should be maintained between the antenna of this device
and persons during device operation To ensure compliance,
operation at closer than this distance is not recommended.
The antenna used for this transmission must not be co-
located in conjunction with any other antenna or transmitter.
Failure to comply with these instructions could result in
death or serious injury.
m
WARNING
The WMPR must be installed in accordance with the
requirements specified in this document in order to
comply with the specific Country Communication Agency
requirements (i.e., FCC, IC, ACMA, etc.). See Section 3
as this
requires choosing the correct Country Use Code and thus
allowable antenna and/or cable usage.
,
CAUTION
Power to the WMPR should not be applied during installation
of an antenna as damage could occur to the WMPR
electronics.
m
WARNING
•
The cable length of the customer-supplied dc power
source to the WMPR supply terminals cannot exceed
three (3) meters.
•
The WMPR must be used indoors.
•
The WMPR must be used inside a cabinet and can only
be accessed during set-up or maintenance.
