Honeywell HX3, User Manual, Page: 31 / 230

2 - 13
Connecting Bluetooth Devices
Before connecting to Bluetooth Devices:
• The system administrator has discovered, paired, connected and disconnected (using LXEZ Pairing Control Panel)
Bluetooth devices for each HX3.
• The system administrator has enabled and disabled LXEZ Pairing parameters for the HX3.
• The system administrator has also assigned a Computer Friendly Name using LXEZ Pairing Control Panel for the HX3.
To connect Bluetooth devices, the HX3 should be as close as possible and in direct line of sight (distances up to 32.8 feet
or 10 meters) with the targeted Bluetooth device during the discovery and pairing process.
If the devices are in Suspend, tap the power key to wake the HX3. Using the correct procedure, wake the targeted
Bluetooth device if necessary.
There may be audible or visual signals as both devices discover and pair with each other.
Taskbar Connection Indicator
LED Connection Indicator
When the Bluetooth LED on the HX3 is off, Bluetooth hardware has been turned off or it does not exist in the HX3.
When the Bluetooth LED on the HX3 is on:
• the HX3 is paired with another Bluetooth device but is out of range or not connected, or
• is paired and connected to another Bluetooth device, or
• is discovering other Bluetooth devices.
The Bluetooth LED
• Blinks slowly (Bluetooth LED is on for one second, off for five seconds) when it is idle.
• Blinks quickly (Bluetooth LED is on for 1/4 second, off for 2 seconds when the HX3 is discovering other Bluetooth
devices.
• And blinks normally (Bluetooth LED is on for 1/2 second, off for 1/2 second) when it is connected.
• There may be audible or visual signals from paired devices as they move back into range and re-connect with the
Bluetooth hardware in the HX3.
HX3 is connected to one or more of the targeted Bluetooth device(s).
HX3 is not connected to any Bluetooth device.
HX3 is ready to connect with any Bluetooth device.
HX3 is out of range of all paired Bluetooth device(s). Connection is inactive.